The Journal
Seattle

Mold or Condensation in a Seattle Rental: Who Fixes What

October 29, 20267 min read

Mold or Condensation in a Seattle Rental: Who Fixes What

Mold in a rental is two jobs: wiping a patch, and fixing whatever keeps it wet. Washington’s Department of Health puts the split in two sentences: “Renters need to operate the heating and ventilation systems to reduce water condensation.” And: “If there is a building problem, it should be fixed by the landlord.” So a small patch on a sill or a caulk line is one EPA says you can usually wipe and dry yourself, a leak or a failed fan is your landlord’s to fix, and the state asks you to report a building problem to your landlord in writing.

Who does what, in the agencies’ own words

QuestionWhat the page saysSource
Leaks, ventilation and heating defects“Landlords are responsible for maintaining rental units, including fixing building problems such as water leaks and ventilation or heating defects which may lead to moisture problems.”Washington State Department of Health, “Renters, Landlords, and Mold”
Telling the landlord“Renters need to notify landlords promptly, in writing, of any water leaks or moisture buildup due to building problems.”Washington State Department of Health
The unit itself“The landlord will at all times during the tenancy keep the premises fit for human habitation”, and the duties that follow include “Maintain the dwelling unit in reasonably weathertight condition”.RCW 59.18.060
Mold information at signingThe landlord must “Provide tenants with information provided or approved by the department of health about the health hazards associated with exposure to indoor mold.” That “information must be provided by the landlord to new tenants at the time the lease or rental agreement is signed”.RCW 59.18.060, subsection (14)
Tenant upkeep“Tenants must meet an owner’s reasonable expectations to maintain rental housing in a safe, clean manner, normal wear and tear excepted.”SDCI Tip 604A, “Updated August 5, 2022”

None of these pages says mold is always the landlord’s problem or always yours. They split it by cause: a building problem is the landlord’s to fix, and limiting condensation by heating and ventilating is the renter’s part. Which side your patch falls on depends on where the water comes from, and nothing here can tell you that for your unit. The Seattle tip carries its own note: “This Tip should not be used as a substitute for codes and regulations.”

Condensation or a leak?

We found no test on these pages that tells the two apart, so read this section as our reading of EPA’s brief guide to mold, moisture and your home, not theirs. The guide says “Condensation can be a sign of high humidity” and advises: “If you see condensation or moisture collecting on windows, walls or pipes act quickly to dry the wet surface and reduce the moisture/water source.” It suggests keeping indoor humidity “below 60 percent (ideally between 30 and 50 percent) relative humidity”.

The same guide gives the line that matters for your decision: “If you clean up the mold, but don’t fix the water problem, then, most likely, the mold problem will come back.” Our practical reading: wipe and dry the patch, heat and ventilate as below, and see whether it returns. A patch that keeps coming back after that points to a water source the building has to deal with, and that is when the letter to your landlord matters most.

What to do this week

  1. Dry and ventilate. EPA: “Run the bathroom fan or open the window when showering.” King County Public Health adds “Heat all the rooms in your home to keep moisture from forming on the walls and other surfaces of unheated areas”.
  2. Photograph it before you clean it. One wide shot for location, one close shot for size, dated. SDCI’s complaint page asks “Where is it on the property?” and “How long has it been happening?”, and photos help you answer both.
  3. Wipe a small patch. EPA’s mold cleanup page says “If the moldy area is less than about 10 square feet (less than roughly a 3 ft. by 3 ft. patch), in most cases, you can handle the job yourself”. Its method is “Scrub mold off hard surfaces with detergent and water, and dry completely.” King County says to wear “an N-95 mask (available at hardware stores), disposable gloves, and goggles” and that “The use of bleach is generally not recommended, unless a sewage release has occurred.” EPA adds “If you have health concerns, consult a health professional before starting cleanup.”
  4. Stop at the size limit. King County: “Get professional help if the mold growth covers more than 10 square feet.” That is also past what a house cleaning visit covers, as the section below explains. Write to your landlord first.
  5. Write to your landlord and keep a copy. SDCI’s tip says “a written request for repairs is often required by law before tenants can exercise any other remedy” and “Remember to keep copies of all correspondence.” Put in the date, your address and unit, where the problem is and roughly how big it is, when you first saw it, that photos are attached, and that you are asking for the source of the moisture to be inspected and fixed.

If nothing happens

SDCI says on its Make a Property or Building Complaint page: “We investigate your complaint and determine whether a property owner violated our codes.” The Tip adds: “If the owner or manager does not make the repair in a reasonable time, you may schedule an inspection by SDCI.” You can call its Violation Complaint Line at 206-615-0808 or use the Seattle Services Portal. Two things from that page: “Your complaint does not always lead to an enforcement action,” and for a problem inside a unit, “our inspector will need to be able to get inside to see it. Usually this means we need permission from the unit’s occupant or the building’s manager.”

When you report it, follow the Department of Health’s advice. It says county or city building code enforcement officials “may take action if building problems are not addressed - they won’t respond to mold complaints, so it’s important to stress the source of the water problem.” Describe the leak, the dead fan or the cold, wet wall, not only the mold. King County’s page also says “Public Health does not conduct mold assessments,” so Public Health is not where a mold check comes from.

For your own rights and for money questions, King County lists free help for low-income renters: the King County Bar Association Housing Justice Project, the Northwest Justice Project and the Tenants Union of Washington State’s Tenants Rights Hotline. The SDCI tip also lists remedies beyond a repair request and says state law has specific rules for them; we are not summarising them here.

Where a house cleaning visit fits, and where it does not

A cleaning visit works on surfaces. Section 4.1 of the Hometress Terms of Service lists, under “Specialized Tasks We Don’t Perform”: “Handling biohazards, mold remediation, dangerous materials, blood, or bodily fluids (these require specialized certified services).” The checklists we publish for Philadelphia bookings cover ordinary surfaces such as window sills and ledges and, on the longer checklists, deeper scrubbing of the tub and showerhead. None of them has a mold line.

Where that leaves a Seattle renter: for a small surface patch EPA says you can usually handle it yourself, and for the bathroom it says that if mold “seems to reappear, increasing ventilation (running a fan or opening a window) and cleaning more frequently will usually prevent mold from recurring, or at least keep the mold to a minimum.” Our guides to cleaning older Seattle homes and the Seattle apartment cleaning checklist cover the technique. What cleaning cannot do is the other half of EPA’s sentence: fix the water problem. Per the Department of Health, a building problem is the landlord’s to fix.

Hometress takes online bookings only in Philadelphia today. If you rent in Seattle, join the Seattle waitlist to hear when online booking opens. The Seattle page also says: “Call or message us now. We’ll tell you what we can do for your address in Seattle.” Moving out? Our Seattle move-out guide covers what landlords look for, including mildew spots and a damp smell.

Common questions

Can a house cleaner remove mold?

A cleaner can wipe ordinary surfaces. Our Terms exclude mold remediation, and for anything bigger than about 10 square feet or after water damage, EPA and King County point to professional help. No cleaning visit fixes the water behind the mold.

Is window condensation my fault?

The Department of Health says renters “need to operate the heating and ventilation systems to reduce water condensation,” and that landlords must fix “ventilation or heating defects.” The pages do not use the word fault. If your heat and fan work and you use them, and the window still runs wet, say so in your letter. If the heat or the fan is what is broken, that is the second kind of problem.

Who pays if my landlord ignores it?

This guide cannot say, and a guess would not help you. SDCI can inspect and, where a code is violated and the owner does not fix it, require corrective action; the tenant-help groups above can advise on money and notice.